A brief description of the components of the automatic barreled water production line
A brief description of each component of the automatic bottled water production line 2017-12-23 09:09 The automatic bottled water production line is suitable for the production of 3 gallons, 5 gallons (18.9L) and other large buckets of water. At present, according to market demand, the output of barreled water production line equipment can reach 150 barrels/hour, 300 barrels/hour, 450 barrels/hour, 600 barrels/hour, 750 barrels/hour, 900 barrels/hour to 2000 barrels/hour. Automatic bottled water production line equipment includes: automatic cap removal machine, empty barrel leak detection device, automatic inner barrel brushing machine, automatic outer barrel brushing machine, automatic barrel loading device, in/out barrel conveying, barreled water filling machine, Automatic capping machine, online barrel lid disinfection machine, light inspection equipment, automatic filming machine, steam shrinking film machine, bucket bagging machine, palletizing machine. The following is a brief description of the various components of the barreled water production line: Automatic cap removal machine: The recycled empty barrels generally come from different environments, such as schools, construction sites, office buildings, etc., and their pollution levels are different. Barrels need to be cleaned manually before entering the barreled water production line. Driven by the conveyor chain, the empty barrel enters the automatic cap pulling machine. After the empty barrel signal is in place, the lid pulling head immediately moves down to pull the lid of the empty barrel, and use the wind system to blow the lid into the designated position for recycling. Recycling. Empty barrel leak detection device: It is used to detect whether there is a leaking barrel, mainly by blowing air into the barrel and observing the pressure gauge. Once the pressure drops sharply, it indicates that the empty barrel has leaks. This barrel must be left out of the barreled water production line to avoid Produce defective products. In the actual production process, the gas consumption is large, and it is generally suitable for large-scale bottled water production. For small-scale bottled water production line manufacturers, its actual intentions are not large. Automatic inner barrel brushing machine: used to scrub the inner surface of empty barrels. After the empty barrel enters the inner barrel brushing machine, once the quantity signal of the empty barrel is in place, the clamping device will act to make the empty barrel immobile. Then, the cylinder Start the action and drive the brush rod to slowly go down into the empty bucket. After the brush rod is positioned, the motor starts to move to drive the brush rod to rotate 360 u200bu200bdegrees. The outer surface of the brush rod is designed with water holes and the brush is rotating. In the process, the water is thrown onto the surface of the bucket, and the inside of the bucket is cleaned in all directions. Automatic outer bucket brushing machine: used to scrub the outer surface and bottom of the empty bucket. After the empty bucket enters the outer bucket brushing machine, once the quantity signal of the empty bucket is in place, the bucket pushing device will act immediately to push the bucket to the brush. Immediately after that, the motor drives the brush to rotate 360 u200bu200bdegrees, and the water spray head aligned with the position of the empty bucket starts to spray to clean the outer surface and bottom of the empty bucket in all directions. The automatic barreled water production line equipment of Niulaan Beverage Packaging Machinery has high production efficiency and stable performance, and it has a leading position in the country.