Aluminum foil sealing machine installation and commissioning and maintenance

by:NEWLINE     2020-08-15
Aluminum foil sealing machine installation and debugging and maintenance - 2019 04 - 10 10:25:26 aluminum foil sealing machine installation and debugging: 1, according to the installation diagram after the machine is out of the installation, and turn on the compressed air source, air pressure to zero. 6 mpa as in the compressed air pipe main meet first to install the valve. 2, open the door spin right out of the oil mist detector for oil standard to clean, or sewing machine oil, note: come on can't bring pressure, oil amount about add to 8 minutes full advisable. 3, into the air check the sealing surface flat, adjust the pressure of 0. 3 to 0. Adjust the volume of feed 4 mpa, general movement several times after a drop of oil injection, regular check injection. 4, filling quantity adjustment: rotary filling quantity first adjust the handwheel, observe the instructions window scale, make the needed to achieve the load, at the same time adjust the suction feeding and discharging speed filling to achieve satisfactory effect, the dosage of the filling amount, the correct filling quantity. Cleaning requirements: comprehensive cleaning before operation, add detergent with soft non-woven cloth to wipe the grease or dirt, and then use non-woven soft dry cloth. In accordance with the GMP requirements, inspection equipment and material contact part is in line with the corresponding requirement of clean, rinse and dry if did not meet again. The cleaning method according to the technological requirements. Can work normally, after completion of installation and debugging for the maintenance of it we give the following Suggestions: 1, aluminum foil sealing filler filling automatic and manual two kinds of action points, when the height of machine adopts manual when using manual, only need to touch the tongue with a bottle a push, which began filling of absorb be sure not to touch the tongue to resist. When using automatic discharging must first put the bottle mouth, switch to instant automatic filling, and in a timely manner to replace the bottle. 2, when found filling measurement is not stable, should check sundries feed check valve may be clamped, cause the untight seal, affect the filling quantity. 3, aluminum foil sealing filler block bottom material leakage, piston sealing ring wear, need to replace the sealing ring. 4, material cylinder, tee part adopts connection, without any special tools, loading and unloading of cleaning is very convenient.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: