Aluminum foil sealing machine should see debug?
24 09:15:04 when we buy a aluminum foil sealing machine equipment, better job if you want equipment, debugging a crucial before it runs.
So the aluminum foil sealing machine should see debug?
1, first of all, unscrew the aluminum foil sealing machine nut and adjustment screw make changed the position of the fixed link.
Thus syringe push-pull length also get change, reach the goal of packing amount adjusted freely.
Screw clockwise to adjust for increment, decrement, conversely pointer how instructions.
2, will immediately after the adjusting nut and tighten, make the fixed link and the crank set firmly.
3, unscrew nuts, according to different syringe push-pull length to determine the correct position of the fixed link.
Under fixed link after adjusted the crank turns a syringe to top dead center, the syringe outer casing levelled up again about 2 mm, in order to avoid bad needle, then after nut tighten, to boot.
4, aluminum foil sealing machine assembly and turn on the switch, the machine work, pulled by the crank to drive syringe and infusion, adjust speed knob, select the appropriate packing speed, began to normal work, adjust the speed knob, clockwise packing speed, slow speed and vice.