Common problems of beverage filling machinery

by:NEWLINE     2021-04-25
Common problems of beverage filling machinery 2017-02-04 08:39 The first is whether the cylinder is in the center of the cylinder bracket, if there is any abnormal movement of the cylinder, please install it from the beginning; the second is the cylinder piston O-shaped seal Whether the ring is damaged, please replace it if it is damaged. The third is that the cylinder piston and the piston rod may be fastened, if they are loose, they need to be locked; beverage filling machinery due to the variety of products produced, but if there is a failure in the production, it will be impossible to produce Underestimate the impact. Therefore, enterprises should learn more about the possible situations of machinery and how to deal with them. It can ensure that the filling machine is more efficient, high-quality, and low-cost to complete the production. The following is the filling machine mechanical engineer summed up the common faults for you, for your reference: Filling machine is filled with inaccurate volume or does not discharge, such as delayed opening, need to adjust the thin cylinder throttle; fast-installed three-way control valve Tighten the elastic force of the spiral spring up and down, if the elastic force is too large, the check valve will not open; is the filling speed too fast, adjust the filling speed throttle valve, and reduce the filling speed; speed throttle valve and filling interval throttle valve Is it closed? The throttle valve cannot be closed; Is there any foreign matter in the quick-installation three-way control valve? If so, please sort it out. Is there air in the quick-installation three-way control valve and the skin tube of the filling head? If there is air, Try to cut or remove the air; check whether all the sealing rings are damaged, if damaged, please replace with new ones; whether the valve core of the filling nozzle has jamming appearance or delayed opening, if there is a jam, install the valve core from the beginning position. Whether all the clamps and hose buckles can be sealed well, please correct them if any; the magnetic switch is not loose, please lock it after adjusting the amount each time. The piston of the material cylinder of the filling machine does not come back after the top, and push to the position of the magnetic switch, and press the emergency stop switch to adjust the active magnetic switch from the beginning.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: