Measures for troubleshooting of beverage machinery
Beverage machinery troubleshooting method 2018-03-21 13:19 The three-in-one filling machine is a combined multi-function unit integrating washing, filling and sealing. It is currently one of the domestic small and medium-sized beverage machinery and equipment with ideal performance. So when this series of beverage machinery breaks down, how can we solve it? 1. Inaccurate filling volume: When filling large-size products, the feed tank is insufficiently filled and the liquid level is unstable. You can increase the filling volume or re-close the ball valve above the filling head to reset the filling time. , Lengthen the filling time and slow down the filling speed to solve the problem. 2. After adjusting the digital dial code or unit, the time does not change, then turn off the power and reconnect the power. 3. The liquid level is stable and the filling volume is not accurate: there is debris blocking the filling channel of the beverage machine, mainly at the entrance of the trough or in the filling mouth. Check and clean it. 4. There is dripping after closing: 1. The orifice of the filling nozzle is damaged, and the filling nozzle can be removed to repair the orifice. The diameter of the orifice cannot be greater than 7.5mm. After repairing the aperture, gently smooth the surface of the orifice on the water scrubbing paper. 2. The ball valve in the filling head is damaged and the ball valve needs to be replaced. 5. No filling after touching the filling switch, the digital indicator LED of the time relay does not flash: the filling switch of the beverage machine is damaged or the base of the time relay is loose, replace the filling switch of the same model or press the base of the time relay tightly. 6. After touching the filling switch, the digital LED indicator of the time relay flashes, but no filling: first check whether there is air pressure or whether the air pressure is too low, it may also be the solenoid valve coil of the beverage machine is damaged or the pneumatic valve core is stolen If it is stuck, you can unplug the power supply, open the board, use the object to turn or press the button next to the solenoid valve coil, if the valve can change direction, it means the solenoid valve coil is damaged, if it cannot change direction, it is the valve core If it is stuck, you can replace the solenoid valve coil or disassemble the valve for repair.